Haven't done the thumbnail dance in a while, but in July I had a good knuckle removal story. It was the usual 3:30 friday evening rush to get done, I was loading green 18' long 1x12's off of a trailer into a storage shed. I had one step to go up, as you enter the narrow door, so I was holding the board about waist high, with my left hand, fingers pointing out, right hand fingers curled under the board, pointing in. As I stepped up, I heard, and felt a "pop", as my pocketwatch face crystal shattered onto hundreds of shards of glass. What shattered it was the pressure of the board, transmitted through the first knuckle, outside surface contacting the glass, inserting the knuckle into the now broken watch face. What made it worse, is that I knew that there was nothing to do now, except grin and bear it, as I leveled out the board, laid it on the stack, and then look at the damage. What had happened is that when I leveled out the board, the watch more or less surgically cut off all the skin on the knuckle, down to, but not hitting anything really vital. I could see white tissue, but not the bone. Kinda felt like sticking your finger in a pencil sharpener! Damnded thing bled like a stuck pig, and throbbed all night. Took the bandage off, looked the same 24hrs later, and started bleeding again. Finally stopped it with a dropper full of Gentian violet solution we had for about 50 years, settin' in the barn. The instant that Gentian violet/alcohol solution hit the hole, I could swear I saw smoke comin'from the wound! That sting was one for the record books.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
