I think what you want for that work is a 4-6 class machine with a root rake. I've got a 4 hightrack and a 6 way blade that has cleared a lot of land. 8" stuff is about all you want to push over with it if you want any measure of control. It can knock bigger stuff over, but a large hardwood can get kinda hairy with that machine if it doesn't want ot go over on the first push and you've got to get under it more..... Sometimes they don't want to wait for you to get that second lift... and they come back to the cab for a visit... I wouldn't even consider a skid steer for the clearing aspect of what you want to do. I'd go with the dozer or an excavator for now and then buy the skid steer later on if I needed that. Keep in mind that the 4H that I have is a 12 tonne/90 hp machine machine and that's about the bottom end for productive land clearing. A 6 or 7 is about the top end because big machines lose a lot of dexterity... and that's more useful than brute power when you're clearing land. You only need enough machine to push your biggest stump out. After that you're losing ground. The 4H is just about the right size for what you want to do... Case 1150 is also in around that area as would the Deere 550 and I believe the Komatsu D65. The Cat's in that class are probably better machines than the Case (I think), but the Case does have split drives to the tracks so you have tremendous manuverability with that machine that the Cat doesn't have with it's ancient clutch and brake steering. If you can afford it, a newer hydrostatic machine would be the way to go...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
