Posted by Gene Dotson on November 26, 2007 at 13:14:34 from (69.88.222.62):
In Reply to: BLOCK HEATER INSTALL posted by JWill on November 26, 2007 at 11:49:12:
I am assuming you have an external tank type heater. For my Case tractors, i install a pipe tee and nipple in the block drain hole. I then drill and tap a 1/4 inch pipe thread hole in the water manifold with a barb hose fitting to attach the outlet hose from the heater. be sure to attach the inlet hose side to the drain fitting and the top outlet to the water manifold side. The inlet for the heater should be at or below the level of the incoming water... Gene P.S. You will want to drain the block before you start and be certain the inlet is clear of all debris.. GD
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
