I'm not a fan of the Ayrshire dairy breed. My maternal grandfather was nearly gored to death by an Ayrshire bull that just in a good mood and was playing around. My Father had a high producing Ayrshire that wasn't kidding about having horns and a tail. She would purposely try to injure, maim,cripple, break or spill anything. I think he just kept her around to keep everybody's wits sharp and for the astounding volume of rich milk. Standard procedure was to carry a sawed off shovel handle as a club. She learned not to get ugly after several weeks with Father but she always looked for any opportunity to make something look like an accident. My Mother put the milking machine on the Ayrshire once before the cow realized it wasn't Father doing the milking. Mother could never get near the Ayrshire again. The cow was cross she missed her chance to make a fuss for somebody new. I milked Ayrshire a few times and she knew at a glance I wasn't Father. She had to get the same treatment to understand she was at least #3 in rank and we were #1 & #2. She would just stand there and glare with pure hatred. On the other hand there was Old Mary who was an almost pure white Holsteinan. One time Old Mary was left overnight in the occasional use dry cow pasture by the barn. When Father was walking from the house to barn in the morning.She appeared around the corner to the gate seconds after hearing the house door open. She pranced like a excited puppy and literally shoved Father with her nose proudly up to her new born calf. It was a sad day for all and maybe even a tear in the corner of a few eyes when we finally admitted she was worn out and just couldn't get in calf any more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
