Posted by Yesmaam on November 15, 2007 at 23:54:59 from (67.1.121.85):
In Reply to: ht3813 timing gear posted by mdauria on November 15, 2007 at 11:10:53:
Info from the Honda HT 3813 Shop manual---Later model 3813 k1 after serial NO. 5100001 camshaft pulley is a tapered fit on the tapered camshaft end. No special removal instructions. Serial # is on right side of frame below muffler.
For early model HT 3813 KO - ser no.5000001 to 5099999 the cam pulley slides on a straight fit with a woodruff key. Shop manual says to remove the 10 mm hex nut & washer and remove the pulley with the rotor puller (special tool no. 89301-400-000) which looks like a pipe plug screwed into the pulley threads to press it off the shaft. Neither model shows the pulley threaded to the camshaft. When reinstalling the pulley tighten nut to 27.5 ft lbs. Dont forget the woodruff key. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
