The last few years we've renetd a disc chisel in the fall for corn, but this year everything is getting turned with the moldboard. We always plow under the old hayfields after we decide to put them in corn. We'll take the 1st crop off and then hit it with the plow.
We've tried the chisel plow a couple times with very limited success on turning old alfalfa into corn. 1 pass doesn't kill it all, and if you work it 2x with the chisel, you might as well do it 1x with the moldboard. Our 4 bottom has a harrow on it so it makes a pretty nice level field when it's done.
I have even noticed that over the last few years, some of our more stubborn/hard fields have been mellowing out a little bit, but I'm a little bit older now and can wait to get out there till it's dry. 2 passes with the cultivator and it's ready for corn. 3 and it's ready for oats/alfalfa again.
Some of the bigger guys are getting into the plow a little more again, and other's never gave it up. All of the farmers around here still use their plow to some extent, but chisel plows are still pretty common.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
