Posted by Roy Suomi on November 03, 2007 at 20:07:29 from (75.185.164.191):
In Reply to: mack b-61 posted by jfh on November 03, 2007 at 15:20:11:
You can go to any NAPA store and request to look at their Heavy Truck Exhaust book..That book either has a listing or sizes[ lengths , pipe sizes , inlet and outlet diagrams]...On my Mack RD-690-P single axle truck , it's got a 4" inlet and a 5" outlet..Whats with that???? Big oval muffler under the cab with a stack up the right side...I used to drive carry-all for Mahnen Machinery years ago..When they sold the Mack tractor there , they came up with a Pete conventional 8V71 with Quadraplex trans..On the break-in trip to the other store the elbow next to the drivers door rotted off , door weatherstripping was gone and the heater motor was smoking profusely..After that trip , I was glad to have a quiet truck to drive...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
