Posted by John T on October 31, 2007 at 14:39:40 from (66.244.83.147):
In Reply to: Polarize Generator posted by Don E. Foster on October 31, 2007 at 10:22:19:
To polarize the genny, you can momentarily temporarily flash/jump/spark a wire from BAT on the VR over to its GEN/ARM terminal and you ought to get a small spark. Same things accomplished if you were to flash/jump/spark a wire from BAT on the VR (or any hot ungrounded battery voltage source for that matter) direct to the gennys ARM post. Do it BEFORE start up. You can first dead ground the Gennys FLD post to insure a good ground but if alls correct n the VR is good n grounded it should already have a ground via the VR. Dont be jumping to the VR or Gennys FLD post, jump to the ARM/GEN post per the above.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
