Posted by K.W. in Tx on October 29, 2007 at 20:21:19 from (71.96.161.118):
In Reply to: 12 valve cummins posted by smdv806 on October 29, 2007 at 19:32:51:
All I can help you with is tell you there is a screw on the back of the injector pump you screw in. Now I aint sayin this is the right way, but its how we always done it here. We turned the screw one rotation at a time til we could tell we had more power. My memory is foggy but I think 3 to 4 turns is as far as we ever would go. If you go to far the inside of the pump will turn to far and blow the motor up. We also turned the interoid screw under the cap on the round thing on top of the pump almost all the way in. But then again this my not be the accurate way of doing it. This is how I used to do it. But if you wanted it to be on the dot I would take it to a good injector shop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
