Posted by kyhayman on October 21, 2007 at 00:02:52 from (64.12.117.74):
In Reply to: planting alfalfa posted by ric1 on October 20, 2007 at 22:18:49:
Seed, $3 a pound at 20 pounds per acre for Evermore, America's 403T or 501. 60 bucks an acre.Grass seed and nurse crop plus renting the cultipacker seeder round it out to 100 bucks an acre plus fuel and time. Lime to bring the soil to pH of 7.0, I normally figure a ton per acre per year but it reallly varies. P and K, K especially. Depends on your soil test and how much reserve you have in your soils. P isnt too bad on me, rarely needed it even after years but K is getting expensive and a crop of alfalfa can suck out a quarter ton a year easy. Then there is either the fuel bill to plow it or the chemical bill to do notil. I blew through $50 of diesel today plowing 8 acres. All in all, not bad considering but still thats money spent. I normally break even mid way through the second year. But then there are those pesky Easter freezes like we had this spring, I lost 20 acres of newly seeded just like that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.