Re: Case SI Steering worm and wormgear

Posted by Gene Dotson on October 17, 2007 at 18:41:09 from (69.88.222.62):

In Reply to: Case SI Steering worm and wormgear posted by Wison-CASE on October 17, 2007 at 16:27:19:

Wilson;

The most common cause of play in Case steering boxes is with wear on the column shaft. The worm gear is on this shaft and can be tightened by removing the column shaft from the top of the transmission. Remove the bolts from the column and remove by turning it out. There is a nut at the bottom with a cotter key to hold it. Remove the key and turn the nut ONLY until play is removed from the gear and the shaft turns freely.
Before you install it, remove the steering arm and thrn the sector gear 1/2 turn and reinstall the arm. Be very careful with the cone bearing on the bottom of the shaft when you reinstall it... Gene

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]