Posted by Bryan in Iowa on October 13, 2007 at 06:11:22 from (64.12.117.74):
In Reply to: 351W posted by jp88 on October 12, 2007 at 14:42:34:
Should be a low comp smogger. cleavland heads will not fit without extensive modifacations $$ Just get some flat top pistons, pick out good aftermarket cam to suit your intended useage.Bore it, grind crank, surface heads and good valve job, and there ya go . Unless your willing to spend $$ with aftermarket heads stock ones will be fine. However,,,If your looking to run rpms up into 4500-6500 range you'll want it to breath , heads and intake are MUST haves . I've been running 351's and 302 's in my stock cars for 15 yrs or so . Great motors with a little help .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
