Posted by Mr. Bob on October 11, 2007 at 09:08:20 from (72.69.88.190):
In Reply to: Re: cut tires posted by LumbrJakMan on October 11, 2007 at 08:50:45:
Thank you very much Lumbrjakman, for your reply. I'd like to see a picture of these close up posted. I have my 12.4's loaded on my 2N and it also once had wheel weights too, until some one apparently "needed" those weights more than I did. It scales 3300# with loaded tires and bumper, less driver and no wheel weights. Thusly equipped, it seems to work very well traction/power wise doing the jobs I use it for. I have beefed up the pto. hp. from the origional 24 aprox. to 30 aprox. and this gives me a very noticable power increase and it handles its own body weight with ease.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
