i gotta get going on my own silage too!i chopped all sunday for a fellow dairy farmer whose chopper puked at the peak of chopping. brought 2 choppers over to his place sunday and filled a 8 by 200ft bag in a day! brought the 3940 JD and the 720 IH over there. both broke down. but the IH outlasted the JD and broke on my last load fer the day. someone welded up the blower band and did a horrible job and the weld let loose. got a new blower band today. she'll be up and running 2morrow. the JD had a in-feed-roller bering go out and it was a special bering. so i got the loacal dealer to open up so i could get the part and get going again. and to think he's got 3 MORE BAGS TO FILL!! same size. sorry fro my droning but just venting. have fun! baggers are fun to watch the tractor running it blow smoke if ya don't have the brake set right! good luck DF in WI
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
