Hope somebody with more experience than I have will tell us both. I planted some here in Michigan last september after I chopped the corn for silage. Drilled it in. The seed is kind of light for broadcasting. It greened up,but didn't get much size. Well,I took a pretty good first cutting of hay from it early this june,no fence around it to pasture it. It was pitifully dry here most of the summer,so I waited to cut the second cutting until way after it went to seed.The third cutting never came on.The roots died. You could pull the dry stems and the roots were just gone. The seed fell off when I cut and raked it. I thought after we got a few little rains,it would sprout,but didn't. So,I hauled a LOT of manure on the field,then disced it in a few days later after a couple of inches of rain. This was later part of august. In three days that stuff was thicker than hair on a dog. I've been going to post about it and ask if I should cut it this fall if it gets tall enough,or if that would hurt the stand and risk winter kill so I won't have it to cut next year?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
