Re: Hold on a minute................

Posted by Bob Kerr on September 03, 2007 at 16:50:43 from (64.12.117.74):

In Reply to: Hold on a minute................ posted by Doug N on September 02, 2007 at 13:13:21:

I thought it got over board also Doug. I know a way to check your wheel weights from the MD to the ollie. Take a large oak plank and put an OLD bathroom scale on the outside end of it. You might need a long plank like 8 ft or longer to keep from smashing the scale, drive the tractor over the plank on the opposite end and have someone look at the dial. then drive the other tractor over it in the same spot. Don"t worry about what the dial says being accurate, just compare the weights you get. That will tell you if the ollie is light in the rear.

Replies:

• Re: Hold on a minute................ Doug N 00:58:04 09/05/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]