Posted by kyplowboy on September 02, 2007 at 17:33:29 from (63.146.226.90):
In Reply to: Re: Hay Covers posted by kyhayman on September 02, 2007 at 07:03:25:
Don't know why so many are so upset. I have plenty of hay (I think) I am just going to be short on cows. Culled pretty deep early this summer while they were still fat. Baled about 2 miles of water ways on a guy up the road. Baled 10 acres of ground 8 miles up the road that a year ago I would have told you I would not have drug a baler across for the hill itself let alone the hay on it. Have about 50 acres of corn stalks to put a hot wire round this fall. 20 more acres of stalks to bale. And still might need to cull a few more mommas. But I think I will have plenty of hay. Oh and I forgot about the 10 acres of early beans I am going plant in Marshall Ryegrass and 4 acres of tobacco ground that is going in wheat as soon as it gets cut.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.