Posted by David, Surrey UK on August 30, 2007 at 09:17:55 from (84.9.75.186):
In Reply to: PTO shaft questions posted by Lanse on August 29, 2007 at 14:13:30:
paul said: (quoted from post at 04:24:56 08/30/07)
Be _very sure_ the shaft does not fully compress itself & is pushing so hard it wrecks something. Most of the time a new shaft needs to be trimmed to fit the thactor the new implement is put on. They often come 'a little too long' to allow for quick hitches, homemade 3pts that are a little out of spec, etc.
I think this may be the answer, as the mower rides quite close to the tractor -- even though I've set it as far back as it will go. The PTO shaft isn't so tight that damage is happening (hopefully) but it might be just tight enough to pop the lock. In any case the shaft's too long for comfortably connecting the ends when the mower's on the the hitch so my next move is going to be to shorten it and see if that improves things.
There's plenty of advice on that on the internet as to how to shorten PTO shafts, so I'll follow that and report back.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
