Posted by paul on August 29, 2007 at 20:24:56 from (66.44.132.223):
In Reply to: PTO shaft questions posted by David, Surrey UK on August 29, 2007 at 14:13:30:
Many implements have a stub shaft with a hole in them for a bolt; smooth shaft no splines; keyed. Some combination of that.
Are you _sure_ the implement end has a splined shaft sticking out of it with the notch in it for the balls to lock into????? Are you sure it looks exactly like the tractor pto shaft? (I know some newer implements do come this way....)
And no, it is _not_ normal or safe to use it the way it is (not) working for you....
Myself I do not like the ring-lock ends, I prefer the single metal button type. I actually replaced an end on my moco because I hated the ring so much. I would try the shaft the other way to see if that locks in better for you?
As you lift & lower the implement it travels in an arc. The shaft will need to extend, retract, & extend again as it moves from all down, to mid height, to all up.
Be _very sure_ the shaft does not fully compress itself & is pushing so hard it wrecks something. Most of the time a new shaft needs to be trimmed to fit the thactor the new implement is put on. They often come 'a little too long' to allow for quick hitches, homemade 3pts that are a little out of spec, etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
