Posted by Don-Wi on August 20, 2007 at 00:20:13 from (69.217.52.59):
According to weather.com we almost got a good 2 inches of rain on Sunday. It was a good slow soaker too, not just in 30 minutes but it was just a drizzle just about all day long. Good enough reason to go to a parish picnic with the fiance and buy some ugly furniture for when I move out in a few months.
At this point I don't care too much about the little bit of scratch that is out there for 3rd crop I cut, we were getting dry and we've got some late season corn that needs it.
We should almost be able to get a little thicker 4th crop too. Dad spread some fertilizer over most of the fields after 2nd, but there was hardly any rain since before I cut 2nd crop so it didn't do much good. Should see some improvement for 4th crop...
Lets see-
Next weekend move the fiance back to her last semester at college and go to a family reunion.
In 2 weeks, have the old Fox 3000 ready for another go at the corn. It's a 4 day weekend for me so we should be able to get quite a bit off.
Then haul manure as I can, cut 4th crop in about 4 weeks and hope it dries down. If not, throw the pick-up back on the 3000 and put it on top of the corn in the silo if there is enough room (hopefully not). Can't forget pumpkin selling season. That'll be starting in about 3 weeks, if not sooner.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
