Posted by Bill(Wis) on August 19, 2007 at 13:58:14 from (71.249.198.251):
In Reply to: farmall super c posted by Duane Wells on August 19, 2007 at 10:04:23:
Farmall C built from '48-'51 had a 113ci engine. Super C followed from '51-54 with a 123 cu engine which added about 5 more HP (23.7 belt and 20.7 drawbar).Serial # for C had a prefix of FC. Super C = FSC. Both had touch control hydraulics. Make sure the hydraulics work. Your main problem might be hooking implements on to it because International used a hitch that accomodated their implements but not the three point. Three point became the industry standard some years later and a tractor really should have it. After market three point hitches are available but expensive. Difficult to build one for a Farmall. Woods has some neat belly mount mowers for older tractors and it's fairly common to see one on a C. They are bullet proof little tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
