Tractor Talk Discussion Board |
Re: Well now
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on August 07, 2007 at 07:26:26 from (12.65.204.187):
In Reply to: Well now posted by Lanse on August 06, 2007 at 18:12:14:
sometimes you can jlay a nut over the stub o fthe broken bolt and weld it on.. be carefull to cover the deck o fthe block to prevent weld spatter ruining your gasket surface. the heat from the weld somethimes helps the bolt break loose. Don't forget other techniques like pb blaster oil, and a medium whack of the head o fthe broke stud with a hammer to help swage the male threads a little.. soundguy
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|