Tractor Talk Discussion Board |
Re: OT - Pulling Single Phase from 3 Phase Service
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David Midkiff on August 07, 2007 at 04:13:58 from (12.40.253.154):
In Reply to: OT - Pulling Single Phase from 3 Phase Service posted by Jim in DE on August 06, 2007 at 18:49:03:
Yes you can get 240 vac single phase from your 480y/277 service. You will need a control power transformer (CPT)480x240v primary, 240x120v secondary, a 600V on/off switch, and 2 fuses/fuse holders, and 12 Gauge wire and lugs, plus a nema 12 box if being used outside large enough to put the components inside. I recommend Square D parts, CPT - 5 kVA part #5S1F (20 amps output), Switch part #2510-KO2, 600V 20 amp fuses and fuse holders of your choice. Connect 1 wire to "A" phase and 1 wire to "C" phase and connect to the 480V side of your CPT. Install switch and fuses between CPT and your 480V source. A electrical supply house can supply you with these items.
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|