Tractor Talk Discussion Board |
Re: OT - Pulling Single Phase from 3 Phase Service
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy S on August 06, 2007 at 19:26:46 from (12.153.204.206):
In Reply to: OT - Pulling Single Phase from 3 Phase Service posted by Jim in DE on August 06, 2007 at 18:49:03:
Yes you can use a transformer to step down the voltage to whatever you need. I do electrical maint for a Vvvvvery large transformer manufacter. All our over head cranes run on 460 and all have a step down transformer to reduce the control voltage to 120v. with no problems. just be sure to fuse the incoming voltage and the outgoing voltage for the safety of your equipment and self. good luck
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|