|
Tractor Talk Discussion Board |
Re: OT Dang Ford Cruise Control
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brokenwrench on August 06, 2007 at 09:56:48 from (75.100.177.237):
In Reply to: Re: OT Dang Ford Cruise Control posted by John T on August 06, 2007 at 09:16:08:
Yeah, it`s possible.
If the vss just glitches at all it should trip a code, and cancel the cruise. The glitch probably won`t be enough to affect the speedo though. If I were you I`d replace the sensor and the connector. You can`t get the connector thru Ford any more, but the standard ignition part # is S699, get it from NAPA or whatever.
Solder and shrink tube the connector in -- don`t use butt connectors or scotch locks. Sitting where it does it`s pretty wide open for moisture and road junk. Also follow the harness up to where it meets the main harness at the frame, sometimes you`ll find where it rubbed thru there as well.. If your friend scans it you will probably find a code 452 stored in memory. Insufficient VSS signal...
Hope you get er fixed. BW
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
