Re: what could go wrong ;)

Posted by glennster on August 06, 2007 at 08:03:42 from (76.223.248.108):

In Reply to: what could go wrong ;) posted by Lanse on August 06, 2007 at 07:41:29:

assuming its a lawn mower motor, you probably have 5/16 inch bolts holding the head on. if you dont have a torque wrench, use a short handle 3/8 rachet, that will limit the force you can apply some, then snug up all the bolts, tighten them in a criss cross pattern a little at a time, but dont overdo it, then start the motor , let it warm up, then shut off and recheck the bolts.

Replies:

• Re: what could go wrong ;) RAB 10:23:40 08/06/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]