|
Tractor Talk Discussion Board |
Re: What model Ford 3600?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on August 03, 2007 at 10:10:33 from (24.224.246.156):
In Reply to: Re: What model Ford 3600? posted by Bob Norton on August 03, 2007 at 08:52:40:
If it has a 6 or 8 speed transmission, then it is possible to add the PTO, and the hydraulics for that matter. Yours would simply have the stripped down housings. The downside is that it won't be cheap.
I would guess that at best you could only add a non-live PTO without changing the transmission.... which would require the output shaft and related parts, the shifter, and probably a drive gear for the transmission unless it has a lower output shaft on the transmission already.
The hydraulics will require a pump, associated lines, lift cover and linkage.
To put it mildly, this will not be cheap even with salvage parts.... and then it would require some research just to figure out exactly what's needed.
The best solution is to buy a parts tractor with a bad engine and swap the back half onto your front if you choose to go ahead with this project... Rod
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
