John Deere 14T feeder fingers

Posted by BritinMaine on August 02, 2007 at 18:16:06 from (12.149.246.23):

Hey, I'm new to these balers. I used this baler last year and had no problems, but for a few shear pin breaks but that was down to dew falling. I just ran it today for the first time this season. I primed it ok by tieing the twine back to the bars next to the fingers. It baled just fine for about 15 bales then stopped tieing knots. I checked the twine and found that the fingers were not feeding the knotter. I tripped the switch manually to prime it again but the fingers never seemed to make a full cycle, just a loud clunk. What am I missing here? Thanks in advance.

Replies:

• Re: John Deere 14T feeder fingers old 19:19:34 08/02/07 (2)
  • Re: John Deere 14T feeder fingers BritinMaine 02:37:43 08/03/07 (1)
    • Re: John Deere 14T feeder fingers old 10:11:25 08/03/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]