|
Tractor Talk Discussion Board |
Re: fence stretching question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Walt Davies on August 01, 2007 at 09:35:36 from (70.41.245.71):
In Reply to: Re: fence stretching question posted by msb on August 01, 2007 at 07:30:47:
The crimps are in the wire so it can go evenly over small rises and dips. with out them you couldn't get a straight fence unless you put it on perfectly flat land. I always stretch the bottom wire first them the top wire. leave the others to find their own tension or use a claw hammer to slightly tighten them. If you have a large dip or sharp hill you may have to put small twists in the wire from top to bottom or bottom to top to take up the slack. After a year or two you will need to retighten the fence. Put a Barb wire strand about 2 in. above the woven fence to keep animals from sticking their head though and pulling it down. I also put a wire in about every 6 or 8 ft. tying the two together. At the end of each 330 ft. section of wire i put in two wood post about 4 ft. a part with a wooden X frame between them. Tie one roll to the far post and the next roll to the other side of the post and tie to the first post set your staple on the other post so that the wire can move. This creates a point where the fence can flex back and forth to keep it tight. Put at least one of these in the center of every run or every 330 ft. I have fences that look good after 4 or 5 years with no extra work on them. where I didn't do this the cows make a mess of the fence. Also remove any fruit trees that are on the other side of the fence the cows will tear down a very good fence to get to them. Don't ask how I know this. Walt
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|