|
Tractor Talk Discussion Board |
Re: Oliver 77 charging system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on July 26, 2007 at 00:00:02 from (195.93.21.134):
In Reply to: Oliver 77 charging system posted by Mike Green on July 25, 2007 at 16:46:03:
When you slip in 'Just rebiult motor.' Did you fit a larger kit than standard?
Has the compression ratio been raised in any other way? If you have, then change to 12 volt, if not sort out the present system. The general opinions on the board are more against 8 volt than for 6. If you look in the archives there will be heaps of posts on the subject. I would think if you compare posts favouring the 8 volt system, over 6 or 12, the percentage is very low.
Me, if it worked OK 50 years ago it should work OK now is the way I look at it. All my tractors are started with the crank handle and I don't 'swing' them, I just lift the handle.
RAB
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
