|
Tractor Talk Discussion Board |
Re: ac wc pto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Athol Carr on July 23, 2007 at 22:17:37 from (219.89.29.62):
In Reply to: ac wc pto posted by Dirty on July 23, 2007 at 20:06:59:
The very early WCs had the power-take-off driven from the belt-pulley drive and there was a side-mount mower pinion on the bottom of the gear-box to drive the mower via a chain drive. It ran sort of diagonally back to the centre of the tractor over the drawbar. Sometime a little later (don't have the parts book handy to check serial numbers) then ran the pto from where the earlier mower pinion was located with the shaft running back under the torque-tube and under the differential where it is found on the later tractors.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|