|
Tractor Talk Discussion Board |
Re: Leaking Oil Seals.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by steve n carol on July 23, 2007 at 22:07:14 from (12.219.251.99):
In Reply to: Leaking Oil Seals. posted by AWB on July 23, 2007 at 16:33:32:
I hope that the vent was the problem. next you might want to check the bearing itself. If it's worn, It will take out a seal. also, if there is excessive end play. Is the seal is fully seated in it's boss. Abraisive in the lube? and my favorite, a loose nut behind the WHEEL! How did the seal, that you removed, look? was it shreadded? worn? oblong?...sl
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
