Tractor Talk Discussion Board |
Re: Why are throwers unpopular?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Darwincam on July 23, 2007 at 11:21:24 from (129.186.120.3):
In Reply to: Why are throwers unpopular? posted by Ryan - WI on July 23, 2007 at 05:33:44:
We didn't get a thrower until my brothers left home...Dad and I were it. I welded a small hydraulic cylinder on to the side of the thrower, and would tweak it to the left and right as I drove, and I could put 10 to 20 more than hand stacked. We just just used long livestock gates on the sides of the rack. I would get to the point where I could slide a bale down the top pipe clear to the end. One thing I didn't like about the bales was if they were left overnight, it seemed like they were all messed up and were a bit more difficult to stack in the barn. None of our neighbors had them...and we were one of the few that picked them up in the field when baled. But then again we were one of the last to have small square bales too.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|