Tractor Talk Discussion Board |
Re: Gooseneck Trailer Axle Positioning
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 135 Fan on July 21, 2007 at 22:41:59 from (68.149.36.26):
In Reply to: Gooseneck Trailer Axle Positioning posted by Matt Weltz on July 21, 2007 at 07:23:24:
I have a factory tandem dually trailer and the place that made it didn't leave enough clearance for the spring mounts in the middle of the two axles. Consequently when I got the trailer (used but like new)one tire was different. After having another tire rub, I knew why the different tire. I took a torch and cut the spring mount back 1/2 an inch so it was flush with the frame. It was only a problem when the trailer was close to maximum capacity but the trailer was mostly used for hauling my Cat which is over 20,000lbs. with the hoe on the back. Dave
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|