Tractor Talk Discussion Board |
Re: driving
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark - IN. on July 19, 2007 at 17:35:40 from (64.12.116.74):
In Reply to: driving posted by Lanse on July 19, 2007 at 15:01:09:
One of those old blue peddle cars down a steep hill, and did at least a couple of flips and rolls, but the doors were welded on, so they didn't fly off like in the movies. Back then, them peddle cars were made of thick durable steel and the only scratchs, cuts, dents, and stitched repairs were on me. My older brother and his buddies shouldn't have pushed me down that hill in the first place, nor should they have said, "Don't worry, you won't get hurt"...and then laughed, "He's going to get killed" as soon as I took off down the hill. Glad I wasn't wearing a seat belt or I would've been killed for sure...it was a convertable. We also used to take turns climbing trees while the others cut them down. The thought was that you could jump out/off just before they hit the ground and not get hurt. It worked in the cartoons. Guess that's why they were cartoons. No wonder Mom had grey hair by the time she turned 29, eh? Ahhhh, to be a kid again. First tractor drove was an H, and it wasn't down a steep hill either.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|