|
Tractor Talk Discussion Board |
Re: OT: Lasic Eye Surgery
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim from PA on July 17, 2007 at 03:40:54 from (130.203.164.37):
In Reply to: Re: OT: Lasic Eye Surgery posted by NC Wayne on July 16, 2007 at 20:34:38:
Wayne my situation is just about the same as yours. I am a machinist and need to see up close as well. I'm 44 and had been wearing the acuvue2 contacts without any real problems for about 10 years. I usually (although not the smartest thing to do) leave my contacts in as long as 2 months at a time with no real problems. My options are to have the surgery and hope it turn out as wished or go back to contacts and if I do try the better 30 day lenses and be a little more cautious with my eyes. Thanks and I will let everyone know what I decide and how it turns out. Jim
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|