Tractor Talk Discussion Board |
Re: OT: 80x110 pole barn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doug in illinois on July 14, 2007 at 18:52:30 from (207.144.221.131):
In Reply to: Re: OT: 80x110 pole barn posted by Triplerange on July 14, 2007 at 18:08:21:
You asked a lot of good questions. I am trying to get more info, I do know that I can't haul any of it it on my trailer, I am farm plated on the flatbed. 150 mile limit, no out of state. I may be able to haul tin, poles, disassembled doors in my 24 ft livestock trailer which is commercial plated. The barn has 15 ft sidewalls, so know the shortest of the poles sawed off will be 15 ft. Planning to use the poles from the center towards the outside and getting "new" poles for the center. They are in concrete, so would just chain saw them off. If I made a couple or three trips with this trailer, do you think the trusses would all go on one big rig? Thanks
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|