|
Tractor Talk Discussion Board |
Re: Tractor acts starved for gas
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jerry/MT on July 12, 2007 at 17:55:57 from (206.183.116.129):
In Reply to: Tractor acts starved for gas posted by Jim D. on July 12, 2007 at 15:02:40:
It sounds to me like you had something in your fuel line/sediment bowl restricting the fuel flow to the carb that you blew out/cleaned out. You said it ran fine after that. I'm not familiar with the specifics of your ignition system but to quickly check the spark after the engine dies, remove the center wire from the distributor cap, turn on the key and try a start while holding the wire near a good ground. (It make take two people to do this.) You should see a FAT,BLUISH-WHITE SPARK FROM THE WIRE. If you do, your ignition is not the problem. If you don't then check out the primary ignition cicuit. Does your carb have a drain plug on the fuel bowl? If it does, open the tank valve and hold a container under the carb and remove the plug The gas should STEADILY gush out LIKE A COW PEEIN' ON A FLAT ROCK for as long as the plug is open and there is fuel in the tank. Do that for 45-60 seconds. If the flow just dribbles or is intermittent then there is a resriction in the fuel delivery. You blew out the gas line but does your sediment bowl have a filter or screen in it? (What did you find when you cleaned out the sediment bowl?)What about the fuel elbow in the carb? A lot of them have a screen in them. You could have a restricted float valve or a flow bowl full of crap and corruption that's not letting the float drop. You float might be damged or the pin could be badly worn. Make sure the vent on the fuel tank is open. Hope this helps you.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|