Re: Welder leads

Posted by Mike Van on July 12, 2007 at 13:20:39 from (24.151.104.209):

In Reply to: Welder leads posted by MN Bob on July 11, 2007 at 14:11:58:

Bob, I"ve got the same welder - Years ago I put 50" of 1/0 wire on for the electrode holder & close to that for the ground. It works fine, I took mine apart and did the wiring right where I took the #2 out. I can"t remember if there were spades crimped on the ends or what? For 1/0 you can make your own spades from 1/2" copper tube, solder them on, flaten the end & drill a 3/8" hole & there"s the spade. The wire is not cheap.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]