Tractor Talk Discussion Board |
Re: Any experience with Hay accumulators?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 044GTO on July 11, 2007 at 10:19:56 from (12.2.115.11):
In Reply to: Any experience with Hay accumulators? posted by DJL on June 26, 2007 at 19:48:53:
Just got a farmhand this year that was sitting idle for several years. After I greased/lubed it, and hooked everything up, it didn"t work. After testing hydro lines, found that pump wasn"t working good. Just turned out to be a seal in the pump. Got it going yesterday and took an hour to tune it in to the bales I like to make (32" @ 45#). Getting pretty good at it after a couple hours of production. Just dont turn a corner when it"s ready to dump the bales, or else they scatter. I"m on hilly ground and it, and still think its the best thing since sliced bread. Baling in 2nd gear - same as with leaving them on the ground.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|