Jubilee rebuild

Posted by jubileejim on July 09, 2007 at 18:25:43 from (76.104.217.44):

I have a Jubilee ran several years ago but had to leave it for several years. It would not start, then found it had a stuck valve, on number two cylinder. Took the head off cleaned and reseated the valves. Took compression test, but only came up to 30 to 40 lbs per cylinder. I put motor oil in the cylinders, and did the check again they came up to 50 to 60 lbs per cylinder. So now I took the engine out pulled the pistons but three of the four pistons looked to have good rings, number four stayed compressed, I assume from carbon build up. I"m no mechanic, but when I took the head off I had oil on the head gasket where I didn"t think it should have gotten because I did tighten to the torque spec. 70 lbs. Any suggestions or thoughts on this?

Replies:

• Re: Jubilee rebuild old 20:51:19 07/09/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]