Tractor Talk Discussion Board |
Re: Ford 7710 wiring diagram
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on July 07, 2007 at 15:31:46 from (24.224.246.156):
In Reply to: Ford 7710 wiring diagram posted by Don Weeks on July 07, 2007 at 14:24:21:
Hmmmmm. Me thinks you not have an electrical problem, but a hydraulic problem which stems from something else falling apart.... The electrical is very straight forward on the DP. The switch is either a dimmer switch or a rocker... either way it's a DP/ST. When it's in high, the solenoid and indicator light are powered. In low only the indicator light is powered while the control valve is spring returned. So... if the lights are working, then it's shifting fine. The only way this could be an electrical problem is if the lights are also slow to illuminate. If it's lazy, it's got a leak somewhere, or the fliter screens in the system are getting plugged. Start at the pump. Look for a 1/2" square headed plastic plug. Remove it and clean the screen. See if that helps. I believe there is also another similar screen in the inlet line to the DP control valve inside the bellhousing, but I've never had to clean that one.... If there is crap in the screens, drop the oil and see what's on the mag plug. If it's got a gray paste that looks like antiseize, the brakes are likely going to pieces, or possibly the DP itself, or any wet clutch inside.... I'm afraid you're heading down an expensive path. Don't neglect this or it will get worse, and it will take more stuff out with it including the pumps (cavitatiopn), brakes (from heat), PTO clutch, DP clutch, FWD clutch, and cause a lot of havoc with the priority valves for the hydraulics. Figure out what's in the oil, and then find where it's coming from.... Rod
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|