Re: Hydraulic Motors

Posted by Wardner on July 05, 2007 at 06:21:34 from (4.154.244.114):

In Reply to: Re: Hydraulic Motors posted by J Schwiebert on July 05, 2007 at 05:34:36:

OK, here are the specifics.

Vehicle is a Clark C-40 forklift. Probably forty years old.

Output port from the original two valve (lift and tilt) goes to a four circuit Vickers forklift valve. A selector on the return port reduces back-pressure on the original two valve and makes the gravity down function quicker when forks are not loaded.

Of the four circuits (a) runs a hydraulic motor that drives an IH Balanced Head sickle bar mower in both directions. It's a hedge clipper now. (B) runs a cylinder that folds the sickle bar, (c) runs a hydraulic winch on the mast, and (d) will run a direct drive (from a Detroit Diesel) air-brake air compressor on one port and a Getec 4000W generator which is also direct drive. Both accessories only need to run in one direction.

Are you confused yet?

BYW, I need one handle for the Vickers. Local shop has one but I don't want to pay his asking price of $50.

Also looking for a gas grill that will tie into forklift propane tank. (Just kidding)

Replies:

• Re: Hydraulic Motors J Schwiebert 18:07:25 07/05/07 (1)
  • Re: Hydraulic Motors Wardner 23:53:17 07/05/07 (0)
• Re: Hydraulic Motors Wardner 06:50:14 07/05/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]