|
Tractor Talk Discussion Board |
Re: inner rear axle seal on '52 8n
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hobo,NC on July 03, 2007 at 18:49:20 from (71.29.35.149):
In Reply to: inner rear axle seal on '52 8n posted by johnz on July 03, 2007 at 16:29:45:
NO, 50 up had the inner seal and the shaft was machine fer it to ride on. BUT it may not B a problem, only if it leaks. 48 and 49 did not use the inner seal so I spec somewhere along the line the axle was replaced. most folks remove the lower bolt on the inspection cover on the side of the rear case were the hydraulic dip stick goes and fill to were it starts to run out the bolt hole and stop, about 4 1/2 gal. That usually will keep the excess out out of the brake shoes. BUT if you have the inner seals and feel you need the extra protection you will need the axle fer a 50 & up 8N
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|