Tractor Talk Discussion Board |
Re: IH 340 Utility question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by vitzarus on July 03, 2007 at 12:33:04 from (67.72.98.85):
In Reply to: IH 340 Utility question posted by MJC on July 03, 2007 at 12:14:32:
I think at the same time the person went to 12v he probably went to negative ground. There were reasons for doing this as the old heavy windings of origional starter could handle this. Along the way certain wiring changes were done through ampmeter or volt gages etc. If you are really sure you want to go original there is sometimes a deal added into the ignition= this is a triad type voltage dropping thing, usually ceramic with 2-3 connectors. The important thing to know is that it allows(thru ignition switch full 12v power During starting but then kicks down the volts to not burn up other stuff. So if this is still in the network it will still reduce the already 6v to less than you need to sustain running.
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|