|
Tractor Talk Discussion Board |
Re: Near-Tragedy Today
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dds-inc on July 03, 2007 at 08:33:28 from (205.188.117.71):
In Reply to: Near-Tragedy Today posted by N. TX Tim on July 02, 2007 at 21:40:47:
Sir... i freak out everytime I load my 2 cylinder putt putts up on a quite steep gooseneck. I tell ya, front end weights are needed badly on two cylinder tractors. I've always been taught to run half throttle, first gear. I've been told to aim the tractor right where you know its going up the ramp, then put the clutch in and go at it straight. When you get up on the trailer, you idle it down first and stop it. I don't carry implements on the back of any two cylinder up on a trailer. They will have to be lifted on it. I hope everyone has a safe hauling season.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
