|
Tractor Talk Discussion Board |
1985 ford model 1910 transmission troubles
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Thomas A Williams on June 29, 2007 at 10:27:21 from (72.45.97.219):
I just bought a used Ford model 1910 four wheel drive and reverser snychronizer transmission (1823 hours)and after two hours of use started having trouble shifting into reverse. Jumped out of third gear to when pulling a brush hog. Pulled the top plate off and springs were in bottom of pan. Gears look good, no metal filings, oil was milky but not dirty. One rail will not go past the detent marks and seems stuck. Can anybody tell me if you can remove a rail and fork with out breaking the tractor in half? Any responses would be grerat. Thanks, Tom
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
