Tractor Talk Discussion Board |
Re: Where to drive?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on June 29, 2007 at 00:09:06 from (69.217.48.36):
In Reply to: Where to drive? posted by flying belgian on June 28, 2007 at 07:03:48:
When I went through the county tractor safety program when I was 12 (10 years ago), they said the best thing to do is hog the lane. In the spring shoulders are soft and you can and will go into the ditch, often rolling a tractor. If you are closer to the shoulder but still in the lane, they still feel like they can pass, even if it's not safe and they don't have room. By hogging the lane they have to check to be sure it's safe before they try to pass. I will pull off to the side if I'm pulling something I can see behind, like a disk or manure spreader or something, but if I can't see around a wagon I'm pulling, I just stay in the lane and expect 20 cars to pass. It's not a problem until I'm ready to pull into the farm drive, then my best shot is to have some on comming traffic where I have to stop or slow down, so they know I have to turn. If the oncoming lane is clear who knows what will happen. That's another reason I prefer to pull wagons at night- I can see the lights behind me if there are any, so I can safely know if I can turn or not. The intersection we always have to go through just got safer. they made it a round-a-bout, so all traffic has to yeild and it akes getting on the main drag (a sate highway) much easier. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|