|
Tractor Talk Discussion Board |
Allis B Mag.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Herb (Maine) on June 24, 2007 at 05:50:50 from (69.95.37.196):
I have a 1946 Allis model B that recently begun to run a little rough of and on. Then one day just wouldn"t fire at all. After some investigation I found the little center pin on the outer Mag cover had broken off. I assume this is the problem. My question is this. The tractor has been converted to a 12 volt system. It also has had a coil, and condensor installed. They basically drilled a hole through the side of the Mag and wired the coil and condensor to the inside of the Mag. with a key (on off switch) wired direct to the coil. I am thinking about putting it back to a straight mag with no coil. Will the mag work on a 12 volt system and is it difficult to switch it back?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
