Tractor Talk Discussion Board |
Re: Hay spear on a loader bucket
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on June 23, 2007 at 23:06:48 from (70.224.199.4):
In Reply to: Re: Hay spear on a loader bucket posted by Joe(TX) on June 23, 2007 at 19:14:50:
To me it seems like they'd be more prone to damage, atleast on our farm. Does make sense though that a smaller cylinder has full potential vs. one that has to pull to curl the bucket though. The bucket on it is just about junk, but it was one we had made 15+ yrs ago for the 1st loader frame that was on the 165 that wasn't built very solid and I was much younger = I trashed it. The Allis frame came on our Oliver 1755 but it was way too small for that tractor,(saw the same one on much smaller Allis tracotrs) although it really wasn't tore up. The 1755 died so we had it retroed to fit the 165. It may be a small tractor, but it's the best loader tractor we've ever had. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|